Spectra-precision ProMark 700 User Guide Bedienungsanleitung PDF herunterladen (Seite 13)

English

Product Storage Spectra Precision recommends you observe the following

rules for long-term storage (2-3 months). These rules are

dictated by the presence of two non-removable Li-Ion

batteries inside the ProMark 700.

• Always charge batteries before long-term storage

• Storage room should be ideally at 5°C (41°F) ambient

temperature to minimize irreversible capacity loss.

• Always charge batteries after long-term storage.

Power/Data

Connector Pinout

Connector socket type: Hirose HR30-6R-6P

Seen from outside the ProMark 700:

Reset Procedure A reset procedure may be required in some situations where

the ProMark 700 does not operate as expected. No user data

will be lost through this procedure. To trigger a reset

sequence:

• Hold the Power button depressed for 12 seconds. Note

that after two seconds of depressing this button, the

ProMark 700 will be turned off or on, depending on the

power status when you started pressing the button. Please

ignore this indication and just keep on pressing the Power

button for the required 12 seconds (starting from the

moment you depressed the button).

• After the 12 seconds have elapsed, release the Power

button. The Power/Charging LED starts blinking red and

green, as it would do on a normal start-up, but this time

for about 25 seconds.

• At the end of the reset sequence, the ProMark 700 will

stay powered and the Power/Charging LED will turn solid

green.

Pin Signal

1 Ground (power)

2 DC Power In (9-16 V)

3Rx (In)

4 Tx (out)

5 Ground (data)

6 Not connected

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Keine Kommentare

Spectra-precision ProMark 700 User Guide Bedienungsanleitung Seite 13