Spectra-precision ProMark 800 Reference Manual Bedienungsanleitung PDF herunterladen (Seite 406)

100

101

394

Output Message Library

• Most of the fields found in the DPC and DBEN data

outputs are similar.

• DPC will not be generated if the [K] option (RTK Base) is

missing.

• DPC data are affected by the last $PASHS,UTS command

run. By default, this command is set to “ON”.

• DPC data are affected by the last $PASHS,ANP,OUT

command run.

• DPC data can be made available on several ports

simultaneously.

• DPC data can be output at a rate of up to 20 Hz, but the

throughput compared to RTCM-3, CMR and ATOM may be

quite higher.

• DPC pseudo-ranges are smoothed by L1 & L2 carriers.

• L2 data are always L2P(Y) data (RINEX code W). To output

complete DPC data, the receiver must be configured

accordingly (see $PASHS,GPS).

Reminder on How

to Output DPC

Messages

Use the $PASHS,RAW command with the syntax below:

$PASHS,RAW,DPC,<port_ID>,ON,<Rate>

For more details on the $PASHS,RAW command, refer to the

Set Command Library Chapter.

As an example, the command below will output DPC

messages on port A at a rate of 1 second:

$PASHS,RAW,DPC,A,ON,1

PBN: Position Information

This message contains position information in binary format.

The message is as follows:

$PASHR,PBN,<structure>

The message’s binary structure is described in the table

below.

Type Name Size Contents

Long pbentime 4

GPS or GLONASS time when data was

received (ms of week). See NOTE below.

Char sitename 4 Site name

Double navx 8 Station position: ECEF-X (m)

1 2 ... 401 402 403 404 405 406 407 408 409 410 411 ... 427 428

Kommentare zu diesen Handbüchern

Keine Kommentare

Spectra-precision ProMark 800 Reference Manual Bedienungsanleitung Seite 406

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Werkzeug Spectra-precision ProMark 800 Reference Manual