Spectra-precision FAST Survey Reference Manual Bedienungsanleitung PDF herunterladen (Seite 348)

100

101

p346

The sequence of shoots started with GPS Simulation storing points 2 and 3 as EP codes. Point 3 was stored as EP END.

A 3D Polyline was drawn between 2 to 3 and GIS prompting popped-up after point 3 was stored shown above. Note in

the Condition field the operator input data not found in the default settings. Point 4 was stored using manual total

station as a UP point code. Point 4’s UP GIS prompting appeared after point 4 was stored. Points 5 through 7 were

stored as a closed polygon. This was done by storing point 7 as EP1 CLO to close back to the start point 5 of the EP1

3D Polyline. The GIS prompting appeared for EP1 (not shown) and entered. The last sequence above was to exit Store

Points and select MAP.

Editing GIS Information on Arcs and Polygons – Input-Edit GIS Data

To edit existing GIS information stored on Arcs (2D/3D Polylines) or Polygons (closed 2D/3D Polylines) in the MAP

pop-up box, select Tools – Edit – Input/Edit GIS Data, and pick any polyline or polygon. There are two figures below.

The top figure shows how the closed 3D Polyline between points 5, 6 and 7 was selected using this command. GIS data

1 2 ... 343 344 345 346 347 348 349 350 351 352 353 ... 397 398

Kommentare zu diesen Handbüchern

Keine Kommentare

Spectra-precision FAST Survey Reference Manual Bedienungsanleitung Seite 348

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Spectra-precision FAST Survey Reference Manual