Spectra-precision FAST Survey Bedienungsanleitung PDF herunterladen (Seite 20)

English

Receiver Tab

Use this tab to set the different operating parameters the

GNSS receiver will use as a base. The table below lists the

parameters you have to set on this tab (and sub-tabs),

depending on the GNSS receiver model you are using.

Additional Information is provided below for some of the

parameters listed above:

• NGS: With this option enabled, FAST Survey will correct

the antenna offset values to get an absolute offset. Keep

it disabled if relative offsets were used in some of the

measurements present in your job.

•

Pos

ition Rate: 1- or 2-Hz position output rate (irrelevant

to a base).

• Use GLONASS: Remember that activating the Use GLONASS

option in ProMark 220 will be effective only if you have

previously set the Tracking mode parameter in GNSS

Toolbox to “GPS L1+GLONASS L1” or “GPS/GLONASS

L1/L2”. As for the Use SBAS and Use QZSS options, only

the last setting made is effective, whether you do it from

GNSS Toolbox or from FAST Survey.

Parameters EPOCH 50 ProMark 220 ProMark 800 ProFlex 800

Antenna Selection NA

Internal/

External

•

NGS

• • • •

Vertical/Slant Height

Measurement

“Vertical”

only

• • •

Antenna Height

• • • •

Elevation Mask

• • • •

Enable Ports B, F

and Ethernet

•

Position Rate

•

Advanced:

Use SBAS

• • •

Use GLONASS

• • •

Use Galileo

• •

Send file after config NA

• • •

NMEA output port

• • •

Configure NMEA

Message

• • •

Use QZSS

• • •

Use GPS

• • •

Source Datum

• • •

Virtual Antenna

• • •

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare

Spectra-precision FAST Survey Bedienungsanleitung Seite 20

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Spectra-precision FAST Survey